so im aware of the ability of that the gm40 can be played through a pc via the red box and an audio interface, when i load up abelton and my focusrite scarlett solo and play i only get the raw sound and nothing from the amp even with it being plugged in via XLR cable. i honestly have no idea what im doing wrong so any help would be appreciated XD
2 posters
noobie tech question
Sabaism- Posts : 12
Join date : 2022-10-20
- Post n°2
Re: noobie tech question
Hi,
Check if you set the correct level at your gm (Line/Mic).
The Amp must be in operation mode, not Standby and you have to increase the Master level to some extend. If you are not using the Speaker Off option and have a speaker connected it could be that you have not enough master level, as the connected speaker will be very loud, depending on the power setting you are using.
Try to switch the speaker off and increase the master level, then you should be able to get some level at your interface.
Best wishes,
Jo
Check if you set the correct level at your gm (Line/Mic).
The Amp must be in operation mode, not Standby and you have to increase the Master level to some extend. If you are not using the Speaker Off option and have a speaker connected it could be that you have not enough master level, as the connected speaker will be very loud, depending on the power setting you are using.
Try to switch the speaker off and increase the master level, then you should be able to get some level at your interface.
Best wishes,
Jo
bordonbert likes this post
|
|